![]() ![]() It’s probably best to leave this part out of your designs. Peter Venkman (played by Bill Murray) referred to the proton packs as "unlicensed nuclear accelerators". Regardless of what level of detail you use to build your proton pack, remember that ghostbuster Dr. N-Filter: Electromagnetic particle filter guides proton stream through neutron wand. Cyclotron: Location/source of particle acceleration alternating magnetic field particle guidance system. Its normally depicted as being attached to their Proton Packs and is sometimes referred to as the Particle Thrower, Positron Collider, Proton Gun, Neutrona Wand, or Proton Blaster. Among the many parts listed on the site’s description, two stand out that might be of particular interest to DIY proton pack makers: The Neutrino Wand here is based on the primary weapon the Ghostbusters use. As such, it provides more information about the quantum physics theory and operation of the proton packs. It is a website and club made up of fans of the Ghostbuster movie. In real life, a proton stream is quite destructive to physical objects.Ī far more provocative proton pack parts list is provided on the Ghostbuster International website, which is described as, “a group of leading worldwide paranormal investigators and eliminators. It fires a stream of highly focused and radially polarized protons that electrostatically traps the negatively charged energy of a ghost, allowing it to be held in the streamįun fact: Modern particle accelerators produce tightly collimated particle beams, unlike the wildly undulating beams emanating from the proton pack from the movie. The nuclear accelerator is used to provide a steady flow of protons to lasso the ghosts in the energy stream. The streams from the neutron thrower trap the ghosts until they can be captured in a ghost trap. Supposedly, ghosts are made up of electrons, neutrons, and a substance known as ectoplasm. Some wires, a hose, and the iconic rainbow ribbon cable are all that is needed to finish the look.Īccording to fan sites, the proton pack emits a particle stream consisting of protons and nuclear energy that attracts the ghost’s psychokinetic makeup. A parts list is provided on the site and the builder promises that it isn’t hard to assemble. Only the Cyclotron parts will need supporting material. Most of the parts can be printed flat on a 3D Printer bed. This then powers the speakers in the back of the pack. A soundboard was included for the SFX, which is toggled by a small set of relays. Fans of the original movie may remember that the neutron thrower or wand was connected by a hose to the proton pack, which supposedly contained a nuclear accelerator in a cyclotronic unit.Īccording to MileyORiley, an Arduino board was used to power the lights on the wand. One example is MileyORiley who posted his Ghostbusters Proton Pack including the Neutron Thrower on Thingiverse. Related: Tech Scares Away COVID During Halloween
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |